In the surface steel blooms, the operation is carried out in the presence of several steel bloom sizess, and the torque required for the screw reel is applied to these rollers. A common combination in the surface screw reel is to have two screw rollers which are in contact with the coil that is screwed. Paper sheets are usually wrapped in this way. In some situations, it is possible that there is also another roller as an adhesive roller. The purpose of inserting the adhesive roller is to fasten the sheet tightly to the mandrel in the first round of twisting. The mandrel is placed between two torsional rollers, and the stainless steel bloom is wrapped into two of these rollers, and then wrapped around the mandrel. Here the adjoining roller plays the role of compression roller.
What are steel blooms?
As noted in the case of Central reeling, different profiles of traction can be used. In the surface screw reel, the problem is a little more complicated because the stretch in a layer of sheet, which is closed on the underlay itself, is not entirely accurate. In some situations, rebound is a combination of these two types. In this case the torque is inserted into two parts. One is the mandrel, which enters the same torque as the one referred to in the central screw reel, and the other is the pushbutton roller. This type of bolted coil is used for a bunch of polymers. The quality and properties of a coil function several parameters.
One of the most important of these parameters is tensile, which makes sheet wrapping. Also, the properties of the material from which the coil is composed such as modulus of elasticity and Poisson coefficient are influential. Sheet thickness and surface quality of steel plate are other parameters component. With the addition of each layer to the coil, the tensions in the coil increase. If the amount of these stresses is high, it can cause imperfections in the coil, which is not desirable and sometimes leads to throw away the entire coil. Therefore, the amount of these stresses should be controlled by the factors that the stress depends on.
Annual sales growth of steel blooms
The main part of the tension Rail is the mandrel, which is actually the shaft around which the sheet is wrapped. Inside the mandrel are segments that provide the ability to change the diameter for the mandrel. In such a way that when wrapping the sheet it is necessary that the diameter of the mandrel is at its greatest. Therefore, the segments are opened and the so-called mandrel becomes obese.
After the end of the coil operation, in order to separate the coil from the mandrel, it is necessary to reduce the diameter of the mandrel or so-called Lean mandrel. In this mode, the segment are closed, and the diameter low-crafted and can be coil out and rails, ready to wrap the coil, Next again, and this process is again repeated.
You can contact us to buy and sell this product:
Sales consultant: Ms. Leila NematzadehWays of communication:
Phone number: 02147623014
Phone number: 04133660491
Phone number: 09120169267
WhatsApp Response (Skype): click